engine mounts

For General Mod and Scooter Discussion and events organised by the Bristol Mod Scooter Club only. All other non-club events to go in the "Gigs and other events" forum.

Moderators: Norm the Newsletter, Steve Holloway, Jim

engine mounts

Postby danny mac » Sun May 03, 2015 6:09 pm

Hi all,anybody got experience of replacing lammy engine mounts ? Graham has the tool ! Does the casing need heating ,and can they be replaced without engine removal ?
danny mac
BMSC member
 
Posts: 90
Joined: Tue Dec 18, 2012 10:51 am

Re: engine mounts

Postby nickwill » Mon May 04, 2015 12:55 pm

Danny,
Chris Powell did some for me a couple of years ago. I put the new mounts in the freezer overnight but didn't have any means of heating the casing, and there were no problems removing the old mounts or putting in the new ones, though the old ones were probably only 3 years old so hadn't had long to get corroded. It might be more difficult to remove 20-year old ones if that's what you've got.
To get at the mounts you need to remove the engine bar and drop the engine unit - with it still attached at the rear shock it should just pivot down. I can't remember what bits we removed to make access easier. I think the carb had to come off - there are probably details on the Net somewhere. The main thing to be wary of is don't use too much brute force if the mounts are stuck, the lugs on the engine case can crack if you start smacking them with a hammer. Be careful refitting the engine bar - it sits in steel cones and needs to be carefully lined-up with the holes in the cones and mounts before tapping into place with a soft hammer or wooden block or you can damage the threads on the bar.
Nick
nickwill
Committee Member
 
Posts: 185
Joined: Tue Apr 07, 2009 10:18 pm
Location: Longwell Green

Re: engine mounts

Postby TV175S3 Chris » Mon May 04, 2015 1:57 pm

Scootopia 3 hole types are good- £30.00 a pair.

Heat not really required although I always run some "Plus Gas" round the join on the old ones prior to extraction.

Make sure the vacant holes where the new mounts go are clean and burr- free, and run a smear of grease round both the hole and the new mount.

Holes on K/S side to be at 3; 4/5; and 6

On the N/S 9; 7/8; 6.

Sometimes pays to chamfer the hole slightly with a quick blast of an appropriate sized 'flap wheel" before cleaning out and greasing.

Chris
Lambretta scootering April 1968 to April 2021. Now retired.
TV175S3 Chris
 
Posts: 369
Joined: Tue Dec 28, 2010 9:56 am


Return to General Scooter and Mod discussion and club events only.

Who is online

Users browsing this forum: No registered users and 35 guests

cron